標準號：ISO 4586-1-2004
中文標準名稱：裝飾用高壓疊層板材(HPL).熱固性樹脂制薄板.第1部分:分類和規范
英文標準名稱：High-pressure decorative laminates - Sheets made from thermosetting resins - Part 1: Classification and specifications
標準類型：G33
發布日期：1999/12/31 12:00:00
實施日期：1999/12/31 12:00:00
中國標準分類號：G33
國際標準分類號：83.140.20
適用范圍：This part of ISO 4586 establishes a classification system for high-pressure decorative laminated sheetsaccording to their performance and main recommended fields of application, including materials with specialcharacteristics, for example postformability or defined reaction to fire.This part of ISO 4586 also specifies requirements on the properties of the various types of laminate covered bythis classification. For several of the properties, more than one test method for checking the requirements isgiven. These methods have been included to cover cases where the results given by alternative methods areapproximately equivalent, where expensive equipment of different types is already in satisfactory use, or whereexperience is limited to only one of the methods in certain countries.Requirements are specified for those types of material that are most generally used, but additional types maybe added as required. The limit values specified apply to the most commonly used types of material, but withineach classification it may be possible to obtain variants having much higher performance figures.These materials are characterized by their decorative surfaces, which are relatively hard and resistant to wear,scratching, impact, boiling water, domestic stains and moderate heat. They are intended for interior applicationsas follows:— thin single-faced laminates usually less than 2mm thick, for bonding to a substrate;— compact laminates, single- or double-faced, approximately 2mm to 5mm thick, which need to be rigidlysupported without necessarily being bonded to a substrate;— compact laminates, self-supporting, double-faced, usually thicker than 5mm, the thickness of which will beselected according to application and panel dimensions.The back surface of sheets having only one decorative face is made suitable for adhesive bonding to asubstrate.This part of ISO 4586 applies only to decorative laminated sheets as defined in Clause 3. ISO 4586-2 specifiesthe methods of test relevant to this part of ISO 4586.