標準號：ANSI/ASTM D4703-2000
中文標準名稱：熱塑模壓試樣、飾板或薄板后試樣的切削、沖壓或機械加工慣例
英文標準名稱：Practice for Compression Molding Thermoplastics into Test Specimens and Plaques or Sheets from which Specimens will be Cut, Stamped or Machined
標準類型：G31
發布日期：1999/12/31 12:00:00
實施日期：2000/12/10 12:00:00
中國標準分類號：G31
國際標準分類號：83.080.20
適用范圍：This practice covers the compression molding of thermoplastic granules and milled stock for the preparation of test specimens. While conditions for certain materials are given, the primary source of specific conditions shall be the material specification standards for each type of material. The values stated in SI units are to be regarded as the standard. The values given in brackets are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1The main body of this practice is equivalent to ISO 293-1986. and ISO 293-1986 differ in some details; however, specimens prepared using , Procedure A should be equivalent to those prepared using ISO 293-1986, Cooling Method D. Specimens prepared using , Procedure C should be equivalent to those prepared using ISO 293-1986, Cooling Method B. However, due to the greater cooling rate tolerances of the ISO standard, specimens prepared in accordance with ISO Cooling Method B may not be equivalent to , Procedure C.