標準號：ANSI/ASTM D3826-1998
中文標準名稱：用張力測定可降解的聚烯烴中降解末端點的實施規程
英文標準名稱：Practice for Determining Degradation End Point in Degradable Polyolefins Using a Tensile
標準類型：G31
發布日期：1999/12/31 12:00:00
實施日期：1998/8/17 12:00:00
中國標準分類號：G31
國際標準分類號：83.080.20
適用范圍：This practice covers the determination of a degradation-end point (a brittle point) for degradable polyethylene/polypropylene films and sheeting less than 1.0 mm (0.04 in.) thick. This practice is not intended for determination of the rate of degree of degradation of a polyethylene/polypropylene film or sheet, but rather, to assess when in the course of its degradation under some condition, a brittle point is reached. If one wishes to monitor tensile elongation during the degradation process (such as when the tensile elongation is significantly greater than 5 %), Test Method D 882 is recommended. This practice should not be considered the only way of determining a degradation-end point. Tensile properties of plastics 1.0 mm (0.04 in.) or greater in thickness shall be determined in accordance with Test Method D 638. Use a static weighing-constant rate of grip separation test. This procedure employs a constant rate of separation of the grips holding the sample and a static load cell. Note 1 -This procedure is based on the use of grip separation as a measure of extension; however, the desirability of using extension indicators accurate to ?1.0 % or better as specified in Test Method D 638 is recognized, and a provision for the use of such instrumentation is incorporated in the procedure. This procedure has been successful for determining the degradation end point of ethylene-carbon-monoxide copolymers and has screened successfully two other additive-type polyethylenes in a round robin test. The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.7 There is no equivalent ISO standard.