標準號：ISO 4759-1-2000
中文標準名稱：緊固件公差 第1部分:螺栓、螺釘、螺栓和螺母 產品等級A、B和C級
英文標準名稱：Tolerances for fasteners - Part 1: Bolts, screws, studs and nuts - Product grades A, B and C
標準類型：J13
發布日期：1999/12/31 12:00:00
實施日期：1999/12/31 12:00:00
中國標準分類號：J13
國際標準分類號：21.060.10;21.060.20
適用范圍：This part of ISO 4759 specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A. NOTE The product grades refer to the size of the tolerances where grade A is the most precise and grade C is the least precise. The tolerances, except tolerances for threads, are selected from the system of limits and fits specified in ISO 286-1 and ISO 286-2. The tolerances for metric threads are taken from the series of tolerance classes specified in ISO 965-3. The tolerances for tapping screw threads are covered in ISO 1478. The tolerances of form and position are specified and indicated in accordance with ISO 1101, ISO 8015 and ISO 2692. The tolerances specified in this part of ISO 4759 apply to fasteners prior to coating unless otherwise specified. See also ISO 4042. Deviations from the tolerances specified in this part of ISO 4759 are only permitted in product standards where there are valid technical reasons. In cases where there is a difference between the tolerance requirements in this part of ISO 4759 and the product standard, the product standard takes precedence. It is recommended that these tolerances also be used for non-standard fasteners. Dimensions and tolerances given in this part of ISO 4759 are in millimetres.