標準號：ISO 23210-2009
中文標準名稱：固定污染源排放.煙氣中PM10/PM2.5質量濃度的測定.低濃度下利用撞擊計進行測量
英文標準名稱：Stationary source emissions - Determination of PM
標準類型：Z60
發布日期：1999/12/31 12:00:00
實施日期：1999/12/31 12:00:00
中國標準分類號：Z60
國際標準分類號：13.040.40
引用標準：ISO 7708-1995;ISO 12141-2002;ISO 20988-2007
適用范圍：This International Standard specifies a standard reference method for the determination of PM10 and PM2,5mass concentrations at stationary emission sources by use of two-stage impactors. The measurement methodis especially suitable for measurements of mass concentrations below 40 mg/m3 as half-hourly averages instandard conditions (273 K, 1 013 hPa, dry gas). It is an acceptable method for the measurement in the fluegas of different installations, such as cement and steel production plants, as well as combustion processes.This International Standard is not applicable to the sampling of flue gases that are saturated with water vapour.This International Standard is not applicable where the majority of the particles are likely to exceed PM10, forexample, in the case of raw gases or plant operating failures.NOTE 1 Measurements of particulate concentrations higher than 40 mg/m3, as a half-hourly average in standardconditions (273 K, 1 013 hPa, dry gas), can lead to overloading of the collecting plates and backup filters and also couldresult in shorter sampling times.NOTE 2 The collecting plates and backup filters can be used for further chemical analysis.This International Standard cannot be used for the determination of the total mass concentration of dust.NOTE 3 For data assessment purposes, it can be useful to perform measurements of total particulate matter in parallelto the PM10 and PM2,5 measurements.This International Standard describes the design, use and theory of round-nozzle impactors. It does notexclude other types of impactors, provided these systems meet the performance criteria specified in thisInternational Standard in a validation of the impactor performed by an independent testing laboratory.