標準號：BS EN 13476-1-2007
中文標準名稱：無壓地下排水和污水塑料管系統.未增塑聚氯乙烯(PVC-U)、聚丙烯(PP)和聚乙烯(PE)結構壁管系統.一般要求和性能特性
英文標準名稱：Plastics piping systems for non-pressure underground drainage and sewerage - Structured-wall piping systems of unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) - General requirements and performance characteristics
標準類型：Q81
發布日期：2007/7/31 12:00:00
實施日期：2007/7/31 12:00:00
中國標準分類號：Q81
國際標準分類號：93.030
引用標準：EN 681-1;EN 681-2;EN 681-4;EN 13476-2-2007;EN 13476-3-2007;EN ISO 472-2001;EN ISO 1043-1-2001;EN ISO 9969;ISO 11922-1-1997;ISO 13967
適用范圍：This European Standard, together with EN 13476-2 and EN 13476-3, specifies the definitions and generalrequirements for pipes, fittings and the system based on unplasticized poly(vinyl chloride) (PVC-U),polypropylene (PP) and polyethylene (PE) structured-wall piping systems that are to be used for non-pressureunderground drainage and sewerage systems.This standard is applicable to:a) structured-wall pipes and fittings, which are to be used buried in the ground outside a building structureonly; reflected by the marking of products by “U”;b) structured-wall pipes and fittings, which are to be used buried in ground both outside (application areacode “U”) and within a building structure (application area code “D”); reflected in the marking of productsby “UD”.In conjunction with EN 13476-2 and EN 13476-3 it is applicable to structured-wall pipes and fittings with orwithout an integral socket with elastomeric ring seal joints, as well as welded and fused joints.This part specifies general aspects and gives guidance concerning a national selection of requirement levelsand classes where part 2 and part 3 of this standard provide options.EN 13476-2 and EN 13476-3 specify material characteristics, dimensions and tolerances, test methods, testparameters and requirements for pipes with smooth internal and external surfaces, Type A, and pipes withsmooth internal and profiled external surfaces, Type B.This standard, together with EN 13476-2 and EN 13476-3, covers a range of pipe and fitting sizes, materials,pipe constructions, stiffness classes and tolerance classes and offers recommendations concerning colours.NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects,taking into account their particular requirements and any relevant national regulations and installation practices or codes.NOTE 2 Pipes, fittings and other components conforming to any plastic product standards referred to in clause 2 canbe used with pipes and fittings conforming to this standard, when they conform to the requirements for joint dimensionsgiven in part 2 and part 3 of this standard and to the performance requirements given in Clause 9.NOTE 3 For dimensions larger than DN 1200 OD/ID this document may serve as general guideline regardingappearance, colour, physical and mechanical characteristics as well as performance requirements.