標準號：BS EN 60684-3-248-2007
中文標準名稱：絕緣軟套管.各種型號套管的規范.收縮比率為2:1、3:1、4:1的阻燃熱縮雙壁聚烯烴套管一般用途
英文標準名稱：Flexible insulating sleeving - Specifications for individual types of sleeving - General purpose, heat-shrinkable, dual wall polyolefin sleeving, flame retarded, shrink ratios 2:1, 3:1, 4:1
標準類型：K15
發布日期：2007/6/29 12:00:00
實施日期：2007/6/29 12:00:00
中國標準分類號：K15
國際標準分類號：29.035.20
引用標準：IEC 60684-1-2003;IEC 60684-2-1997;IEC 60684-2/A1-2003;IEC 60684-2/A2-2005;IEC 60757-1983;ISO 1817-2005
適用范圍：This part of IEC 60684 gives the requirements for six types of general purpose, heat shrinkabledual wall polyolefin sleevings, flame retarded with nominal shrink ratios of 2:1, 3:1 or 4:1 andavailable in low and high temperature adhesive inner walls.The low temperature adhesive sleeving has been found suitable for temperatures up to 105 °Cand the high temperature adhesive sleeving has been found suitable for temperatures up to125 °C.? Type AL:2:1 shrink ratio, internal diameter up to 51 mm, low temperature adhesive inner wall.? Type AH:2:1 shrink ratio, internal diameter up to 51 mm, high temperature adhesive inner wall.? Type BL:3:1 shrink ratio, internal diameter up to 40 mm, low temperature adhesive inner wall.? Type BH:3:1 shrink ratio, internal diameter up to 40 mm, high temperature adhesive inner wall.? Type CL:4:1 shrink ratio, internal diameter up to 52 mm, low temperature adhesive inner wall.? Type CH:4:1 shrink ratio, internal diameter up to 52 mm, high temperature adhesive inner wall.The sleeving consists of an outer layer being of a flexible cross-linked polyolefin. The inner wallconsists of a hot melt adhesive that flows and fuses during the shrinking process to provide abond.These sleevings are normally supplied in colour black.Sizes or colours other than those listed in this standard may be available as custom items.These items are considered to comply with this standard if they comply with the propertyrequirements listed in Tables, 5 and 6 and Table 8 where applicable, with the exception ofdimensions.Materials which conform to this specification meet established levels of performance. However,the selection of a material by a user for a specific application should be based on the actualrequirements necessary for adequate performance in that application and not based on thisspecification alone.