標準號：BS EN 62339-1-2007
中文標準名稱：表面安裝流體分配部件用模塊元部件接口.彈性密封件
英文標準名稱：Modular component interfaces for surface-mount fluid distribution components - Elastomeric seals
標準類型：G43
發布日期：2007/5/31 12:00:00
實施日期：2007/5/31 12:00:00
中國標準分類號：G43
國際標準分類號：21.140
引用標準：ANSI/SA-76.00.02-2002
適用范圍：This International Standard applies to all types of surface-mount fluid distribution components withelastomeric sealing devices used within process analyser and sample-handling systems. This includescomponents such as valves, filters, regulators, transducers, and controllers.The scope of this standard is limited as follows.a) This standard addresses only surface-mount fluid distribution components and proper sealingmethods. This standard is limited to sealing methods using elastomeric material for the seals.b) The designs of the actual system components and the flow substrate are not specified in thisstandard. Any indication of mounting direction or other indexing is left to the manufacturer asrequired for its equipment.c) Users shall be aware that, on the basis of the stream conditions of their processes, othertechnologies and components may be readily available.d) This standard does not address the effects of various stream conditions on the technicalfunctionality of the component.e) This standard does not address maintenance concerns for the components.f) This standard does not refer to design issues pertaining to specific safety requirements.These issues should be referenced to other standards, organizations, and recommendedguidelines.g) International, national, and local codes, regulations, and laws should be consulted to ensure thateach component meets the user's regulatory requirements.The object of this standard is to establish properties and physical dimensions that define the interfacefor surface-mount fluid distribution components with elastomeric sealing devices used within processanalyser and sample-handling systems. The interface controls the dimensions and location of thesealing surfaces to allow change of just one element of the system without modification of the entiresystem. This is what makes the system modular from both a design and a maintenance standpoint.