標準號：BS ISO 16063-21-2003
中文標準名稱：振動和沖擊傳感器的校準方法.與基準傳感器比對進行振動校準
英文標準名稱：Methods for the calibration of vibration and shock transducers - Vibration calibration by comparison to a reference transducer
標準類型：L15
發布日期：2003/9/2 12:00:00
實施日期：2003/9/2 12:00:00
中國標準分類號：L15
國際標準分類號：17.160
適用范圍：This part of ISO 16063 describes the calibration of rectilinear vibration transducers by comparison. Although it mainly describes calibration using direct comparison to a standard calibrated by primary methods, the methods described can be applied between other levels in the calibration hierarchy. This part of ISO 16063 specifies procedures for performing calibrations of rectilinear vibration transducers by comparison in the frequency range from 0,4 Hz to 10 kHz. It is primarily intended for those who are required to meet ISO standardized methods for the measurement of vibration under laboratory conditions, where the uncertainty of measurement is relatively small. It can also be used under field conditions, where the uncertainty of measurement may be relatively large. From knowledge of all significant sources of uncertainty affecting the calibration, the expanded uncertainty can be evaluated using the methods given in this part of ISO 16063. It also covers the assessment of uncertainties for calibrations performed using a check standard. Comparison calibrations made in accordance with this part of ISO 16063 need to allow for the environmental conditions of the reference transducer calibration. NOTE Transducer calibrations made under extreme environmental conditions are covered by other International Standards.