標準號：ANSI/ASTM D635-1998
中文標準名稱：水平位置自支撐式塑料的燃燒率和/或燃燒程度與燃燒時間測試驗方法
英文標準名稱：Test Method for Rate of Burning and/or Extent and Time of Burning of Self-Supporting Plastics in a Horizontal Position (08.01)
標準類型：G31
發布日期：1999/12/31 12:00:00
實施日期：1999/12/31 12:00:00
中國標準分類號：G31
國際標準分類號：83.080.01;13.220.40
適用范圍：This fire-test-response test method covers a small-scale laboratory screening procedure for comparing the relative linear rate of burning or extent and time of burning, or both, of plastics in the form of bars, molded or cut from sheets, plates, or panels, and tested in the horizontal position. Note 1This test method, and test method A of IEC 60695-11-10 are technically equivalent. Note 2For additional information on materials which do not burn to the first reference mark by this test, see Test Method D 3801. This test method was developed for polymeric materials used for parts in devices and appliances. The results are intended to serve as a preliminary indication of their acceptability with respect to flammability for a particular application. The final acceptance of the material is dependent upon its use in complete equipment that conforms with the standard applicable to such equipment. The classification system described in is intended for quality assurance and the preselection of component materials for products. This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazards or fire risk assessment of materials, products, or assemblies under actual fire conditions. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see .