標準號：ANSI/ASTM D2843-1999
中文標準名稱：塑料燃燒或分解釋放煙密度測試方法(08.02)
英文標準名稱：Test Method for Density of Smoke from the Burning or Decomposition of Plastics (08.02)
標準類型：G31
發布日期：1999/12/31 12:00:00
實施日期：2000/1/18 12:00:00
中國標準分類號：G31
國際標準分類號：83.080.01
適用范圍： This fire-test-response test method covers a laboratory procedure for measuring and observing the relative amounts of smoke obscuration produced by the burning or decomposition of plastics. It is intended to be used for measuring the smoke-producing characteristics of plastics under controlled conditions of combustion or decomposition. Correlation with other fire conditions is not implied. The measurements are made in terms of the loss of light transmission through a collected volume of smoke produced under controlled, standardized conditions. The apparatus is constructed so that the flame and smoke can be observed during the test. Caution-During the course of combustion, gases or vapors, or both, are evolved that may be hazardous to personnel. Adequate precautions should be taken to protect the operator. The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information purposes only. This standard should be used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire-hazard or fire-risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire-hazard assessment or a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard or fire-risk of a particular end use. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 1.2 and Note 7. -There is no similar or equivalent ISO standard.