標準號：BS EN 1536-2010
中文標準名稱：專門的巖土工程的實施.管樁
英文標準名稱：Execution of special geotechnical works. Bored piles
標準類型：P21
發布日期：2010/9/30 12:00:00
實施日期：2010/9/30 12:00:00
中國標準分類號：P21
國際標準分類號：93.020
適用范圍：1.1 This European Standard establishes general principles for the execution of bored piles (see 3.2).1.2 This European Standard applies to bored piles (see Figure 3) with:? uniform cross-section (straight shaft);? telescopically changing shaft dimensions;? excavated base enlargements; or? excavated shaft enlargements.1.3 This European Standard applies (see Note) to:? bored piles with a depth to width ratio ≥ 5;? piles (see Figures 1 and 3) with a shaft diameter 0,3 m ≤ D ≤ 3,0 m;? barrettes (see Figure 2) with the least dimension Wi ≥ 0,4 m, a ratio LBiB / Wi between its largest and itsleast dimensions ≤ 6 and a cross-sectional area A ≤ 15 m?;? piles with circular precast elements used as structural member (see Figure 7) with a least dimensionDP ≥ 0,3 m;? barrettes with rectangular precast elements used as structural member with a least dimensionWP ≥ 0,3 m.1.4 This European Standard applies to piles with the following rake (see Figure 4):? n ≥ 4 (Θ ≥ 76°);? n ≥ 3 (Θ ≥ 72°) for permanently cased piles.1.5 This European Standard applies to bored piles with the following dimensions of the shaft or baseenlargements (see Figure 3):a) base enlargements:1) in non-cohesive ground: DB / D ≤ 2;2) in cohesive ground: DB / D ≤ 3;b) shaft enlargements in any ground: DE / D ≤ 2;c) slope of the enlargement in non-cohesive ground m ≥ 3;1) in non-cohesive ground: m ≥ 3;2) in cohesive ground: m ≥ 1,5;d) base enlargements area of barrettes: A ≤ 15 m?;1.6 The provisions of this European Standard apply to:? single bored piles;? bored pile groups (see Figure 5);? walls formed by piles (see Figure 6).1.7 The bored piles which are the subject of this European Standard can be excavated by continuous ordiscontinuous methods using support methods for stabilizing the excavation walls where required.1.8 This European Standard applies only to construction methods that allow the designed cross-sections tobe produced.1.9 The provisions apply to bored piles (see Figure 7) constructed of:? unreinforced (plain) concrete;? reinforced concrete;? concrete reinforced by means of special reinforcement such as steel tubes, steel sections or steel fibres;? precast concrete (including prestressed concrete) elements or steel tubes where the annular gapbetween the element or tube and the ground is filled by concrete, cement or cement-bentonite grout.1.10 Micropiles, mixed-in-place columns, columns constructed by jet grouting, ground improvement for piling,mixed-in-place pile bases and diaphragm walls are not covered by this European Standard.