標準號：BS PD CISPR/TR 16-2-5-2008
中文標準名稱：無線電干擾和抗擾度測量儀器和方法規范.第2-5部分:由體積較大的設備產生的干擾發射的現場測量
英文標準名稱：Specification for radio disturbance and immunity measuring apparatus and methods — Part 2-5: In situ measurements of disturbing emissions produced by physically large equipment
標準類型：L85
發布日期：2009/7/31 12:00:00
實施日期：2009/7/31 12:00:00
中國標準分類號：L85
國際標準分類號：33.100.10
引用標準：CISPR 16-1-1;CISPR 16-1-2;CISPR 16-1-4;CISPR 16-2-1;CISPR 16-2-3
適用范圍：This part of CISPR 16 deals with in situ electromagnetic disturbance measurements in anyenvironment from physically large equipment and systems excluding networks.It covers both radiated and conducted emission phenomena, and does not deal with immunitytests.This technical report is intended to be applied primarily to such physically large equipmentwhich are not under the scope of any existing emission standards (as for example CISPR 11and CISPR 22). It serves only as a guideline on how to deal with emissions of that equipmentat the particular location of installation. It does not establish any emission requirements.NOTE 1 Although this technical report is intended to be applied to equipment which is not under the scope of anyexisting emission standards, it may be used also in such cases in order to serve as additional information forcarrying out in situ measurements for any type of large equipment.NOTE 2 Examples of large equipment are: production machines, conveyors, large displays, aircraft simulators,traffic control equipment, etc.Due to the severe impact of the conditions existing at a particular location of operation andthe use of the respective large equipment, however, it is not intended to use themeasurements in the frame of type testing.NOTE 3 In general, type testing on large equipment is only possible at standardized test sites in a controlledenvironment. The assessment results obtained under in situ conditions are only valid for the respective individuallarge equipment actually measured at its particular place of installation. These results cannot be transposed toother equipment of the same type, but installed at other locations.Reference in-situ measurement distances will be given. This allows comparison of themeasurement results with limits from existing relevant standards.The frequency range under consideration is from 9 kHz to 18 GHz.Dealing with biological effects on living matter is excluded from this document.