標準號：ANSI/ASTM A1013-2000
中文標準名稱：受控溫度下軟磁芯元件高頻(10 kHz - 1 MHz)磁芯損失試驗方法
英文標準名稱：Test Method for High Frequency (10 kHz - 1 MHz) Core Loss of Soft Magnetic Core Components at Controlled Temperatures using the Voltmeter-Ammeter-Wattmeter Method
標準類型：L19
發布日期：1999/12/31 12:00:00
實施日期：1999/12/31 12:00:00
中國標準分類號：L19
國際標準分類號：29.100.10
適用范圍：This test method covers the equipment, procedures, and measurement of core loss of either toroidal or mated soft magnetic core components, such as soft ferrite cores, iron powder cores, and so forth, over ranges of controlled ambient temperatures typically from 20 to +120C, frequencies from 10 kHz to 1 MHz, under sinusoidal flux conditions. The values and equations stated in customary (cgs-emu and inch-pound) of SI units are to be regarded separately as standard. Within this test method, SI units are shown in brackets except for the sections concerning calculations where there are separate sections for the respective unit systems. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.